User Guide

11
Rear panel functions
3 4 6 5
2 1 7
1) Mains. Supplied via an IEC standard 3-pin connector. A compatible
power cord is supplied with the unit.
2) Voltage Changeover Switch. The unit can be set for 220v or 110v
operation. The switch is recessed behind a panel which indicates the voltage
selected. Removal of this panel allows the switch position to be changed. The
panel must then be turned around before it can be replaced and it will
indicate the required mains voltage.
3) Mains Fuse. Always replace with the correct type and rating of fuse, as
indicated adjacent to the fuseholder.
Audio connections are made via balanced XLRs. For wiring details please see the
Audio Connections section of this manual on page 15.
4) Pre-Fade Listen output (PFL).
5) Inputs.
6) Direct Outputs.
7) Matrix Outputs.