User Guide

LEFT INPUTRIGHT INPUT LEFT LINK INPUTRIGHT LINK INPUT LEFT OUTPUTRIGHT OUTPUT
PUSH
PUSH
PUSH
PUSH
Left and right link inputs: When used in a daisy chain, the link input is summed with the output from
the XL42's input channels to the output so that the daisy chain may continue. A much larger console can
be created by adding extra XL42s using the output from the last XL42 in the chain as the master output.
Input impedances: 20kOhm Balanced
Maximum input level: +21dBu
The Left and Right link inputs may be configured using internal jumpers to sum with the channel input Pre-
or Post- Output Level, Pan and Mute. The factory default setting is post Output Level, Pan and Mute.
Left / Right Output: Balanced XLR output from the channel strip.
The output signal will be a combination of the link input plus the output from the XL42's input
channels. If pan is selected on either of the inputs, the outputs will be a stereo combination of the
input channels plus the link input. If pan is disabled on the channels, the output will be a
combination of the input channel and the link input only.
Please note that if one input channel has pan enabled and one does not, the channel with pan
enabled obeys the pan law of the pan pot. However, no signal is introduced into the other output.
Only when both channel pan switches are enabled does the unit enter full stereo mode, that is,
either output can be a combination of either input.
Maximum output level: +21dBu
The Left and Right Outputs may be internally configured using jumpers to be pin 2 or pin 3 hot.
Factory default setting is pin 2 hot.
XL42 Operators Manual - Page 10
Rear PanelRear Panel
Left and right inputs: Balanced XLR input to the channel strip
from microphones, DI boxes, line etc.
Input impedances: Mic: 2kOhm Balanced
Mic (with PAD): 3kOhm Balanced
Maximum input level: Mic: +6dBu
Mic (with PAD): +31dBu