User Guide

Output section
level/pan dual concentric rotary control knob:
PAN PAN
PAN
Adjusts pan or output level.
Pan control places the input within a stereo (left/right) mix and has a constant power law
such that, at its centre position, each output is attenuated by 3dB. Pan control is enabled by
the switch (immediately below) and is adjusted using the outer control ring. With
switch off, the XL42 is essentially two independent channel strips. With switch on, the
output signal from each input strip is distributed between the two outputs.
The output level, adjust by the inner control knob, controls the output level in the range -
(infinity) to +10dB.
¥
INS switch:
Note:
Selects whether the insert
circuitry is patched into the audio signal
path. When the switch enabled (on, fully in
position) then the insert jacks are patched
into the audio signal path.
the insert point can be configured
internally using jumpers to be pre- or
post- EQ. The factory default setting is
Pre-EQ.
MUTE switch: Mutes the channel outputs. Mute may
also be controlled via the Automute link selected via the
"REMOTE CONTROL AUTOMUTE ASSIGNS" DIP switches
on the rear panel
Output peak level meter: Monitors
the level of the channel. By default,
this is post-output level and pan,
although it may be internally set to be
pre-level pan and insert.
PAN switch:
level/pan
Enables the pan control on the
dual concentric rotary control knob.
Front PanelFront Panel
XL42 Operators Manual - Page 8