User Guide

act
scene
store
a
b
active system
(hold 3secs)
lock
s-i-p
midi system
delete
copy
insert
check
confirm
cancel
now
down
next
act/scene
c/o
last
up
Snapshot Automation System
The LOCK switch will toggle state each
time it is pressed. When the LOCK
switch is illuminated all assignment
changes are disabled. The console will
automatically revert to a locked state if
no assignment controls are operated
within a 90 second period.
The SOLO IN PLACE switch sets the
console to solo in place mode. In this
mode any input solo that is pressed
activates a mute of all the other channels.
To protect against accidental operation
the solo in place switch must be pressed
for 3 seconds before it will operate.
The A/B switch selects which micro card
is controlling the console assignment
and automation systems.
This is a major function! At the point of
change over there is no defined control
of the console signals. The A/B switch
should there for be treated with the same
cautions used at console power
up/down.
For reliability the assignment and
automation systems are 100%
duplicated. The console can operate on
either of the systems. All snap shots are
stored on BOTH of the systems. The
LEDs indicate the status of each system
in the following manner:-
LED green indicates which system is
active
LED off indicates which system is
inactive
LED red indicates that a system is
damaged or not responding and
that a service engineer must be
called as soon as possible.
Operating the STORE key will store the
current console assignments and settings
to the snap shot being displayed on the
numeric display.
The MIDI key allows the operator to edit
the snap shot MIDI information. On
entering this mode the operator will be
presented with a menu of the four MIDI
messages that are stored within each
snap shot, its operation is similar to the
system menu.
28