User Guide

10
10
5
5
0
20
15
30
40
vca 2
vca 1
1 vca 2
MUTE MUTE
SOLO SOLO
The VCA MUTE switch acts on the
pre and post fader signals of any
input channels which are assigned to
the VCA master. The switch can be
controlled from snapshot
automation. If desired the MUTE
can be changed to operate as an
independent AUTO MUTE switch.
This is setup in the SYSTEM menu
on the central automation control.
The VCA SOLO switch is used to
monitor the VCA master fader by
creating a mix on the solo busses
which consists of all input channels
which are assigned to the VCA
master. If a VCA solo switch is
pressed for a short time it will latch
on or off, but if it is held on for more
than 1 second the latching is
disabled and when the switch is
released the solo will turn off.
When the console is operating in
SOLO ADD MODE input channels
have priority over VCA solos and
will temporarily override them.
The VCA MASTER FADER
controls the output level of any input
channels which are assigned to the
VCA master from +10dB to off.
VCA Master Section
18