User Guide
Mono Pod ModuleMono Pod Module
Stereo Pod ModuleStereo Pod Module
Optics ModuleOptics Module
mono pod module
c
l
r
c
l
r
c
l
r
c
l
r
c
l
r
c
l
r
c
l
r
c
l
r
c
l
r
0
0
0
0
0
0
0
0
MIDAS
H4002
n
a
p
n
i
a
g
PRE
1
PRE
2
PRE
3
PRE
4
PRE
5
PRE
6
PRE
7
PRE
8
stereo pod module
MIDAS
H4005
0
gain
+6
0
gain
+6
0
gain
+6
0
gain
+6
0
gain
+6
0
gain
+6
0
gain
+6
0
gain
+6
PRE
1
PRE
2
PRE
3
PRE
4
PRE
5
PRE
6
PRE
7
PRE
8
The mono input pod is connected to the mono channel strips on the main Heritage 4000 console internally, hence
there are no connections directly to it on the rear of the pod.
The mono pod module allows the routing of signal to the 8 stereo auxes (outputs on the rear of the auxtender
pod).
Each stereo aux send is enabled by depressing the switch adjacent to the dual-concentric pan/gain
potentiometer. When enabled, the accompanying LED will illuminate according to the pre/post switch.
The pre/post switch determines whether the signal is sent PRE or POST Fader. This is displayed on the LED as:-
GREEN - Aux send is enabled and POST-Fader
RED - Aux send if enabled and PRE-Fader
The inner ring of the dual-concentric pot provides gain control for the aux send while the outer ring provides the
PAN (left-to-right balance) control allowing the user to position the channel within the stereo aux image.
NOTE: Unlike the Heritage 4000’s 24 assignable buss outputs, the stereo auxiliaries are always auxes.
The stereo input pod is connected to the stereo channel strips on the main Heritage 4000 console internally, hence
there are no connections directly to it on the rear of the pod.
The stereo pod module allows the routing of signal to the 8 stereo auxes (outputs on the rear of the auxtender
pod).
Each stereo aux send is enabled by depressing the switch adjacent to the dual-concentric pan/gain
potentiometer. When enabled, the accompanying LED will illuminate according to the pre/post switch.
The pre/post switch determines whether the signal is sent PRE or POST Fader. This is displayed on the LED as:-
GREEN - Aux send is enabled and POST-Fader
RED - Aux send if enabled and PRE-Fader
The pot provides gain control for the aux send which is continuously variable from off (-inf) to +6dB.
NOTE: Unlike the Heritage 4000’s 24 assignable buss outputs, the stereo auxiliaries are always auxes.
On the Heritage 4000 the control for the optics system has been moved to the auxtender pod.
The optics system is controlled from the front panel on the auxtender pod.
- Brightness of the desk lamps (XLR Sockets on the rear of the console aux-extender pod).
- Turns the XLR lamps on (depressed) or off (released).
- The brightness of the LEDs in the console surface (with the exception of the major function
LEDs) can be controlled.
Brightness
ON
LED Brightness
optics module
led
brightness
_
+
H4052
brightness
_
+
NO
Operators Manual- Page 17