User Guide

sig
gen
on
stereo
monitor
source
freq (hz)
talk
mic
50
150
5k
500
head
phones
0
+10
local
monitor
0
+10
0
+6
mono solo
0
+6
stereo solo
0
+6
0
+10
level
level
talk
to
gain
20
60
40
mono
monitor
source
PINK
MUTE
MUTE
NEUTRIK
1
2
3
TAPE
ST
ST
MONO
MONO
SOLO
GROUP
SIS
SOLO
MONO
The FREQ. control gives continuous
adjustment of the oscillator frequency
from 50Hz to 5K.
The generator LEVEL control gives
continuous adjustment of the signal
generator peak output signals from
+10dBu to off.
The PINK switch overrides the
oscillator by giving a pink noise
output.
The GENERATOR ON switch
connects the signal generator output to
the console's internal talk busses and to
the talk external output XLR.
The talk to GROUP switch connects
the talk mic and generator circuits to
ALL group busses.
The talk to MONO switch connects the
talk mic and generator circuits to the
mono master bus.
The talk to ST switch connects the talk
mic and generator circuits to the stereo
master busses.
The TALK XLR socket accepts
balanced 150 Ohm microphone
signals.
The TALK MIC ON switch connects
the signal talk mic output to the
console's internal talk busses and to the
talk external output XLR. At the same
time it also dims all the local monitor
outputs by 20dB to prevent howl
round.
The MIC GAIN pre-set gives
continuous adjustment of the
microphone amplifier gain from
+20dB to +60dB and operates in
conjunction with a peak limiter which
is factory set to +10dBu.
The talk LEVEL
gives continuous
adjustment of the
post limiter signals
from +10dB to off.
The MONO SOLO TRIM adjusts the
incoming solo level before sending it
to the monitor output. The control
range is from +6dB to off with a center
0dB calibration point.
The STEREO SOLO TRIM adjusts the
incoming solo level before sending it
to the monitor output. The control
range is from +6dB to off with a center
0dB calibration point.
The MONO master switch routes the
post fader mono master mix to the
mono local monitor output.
The SOLO switch routes solo signals
to the mono local monitor output when
ever a solo is active on the console.
This overrides any signals sent from
the mono master.
The SIS switch routes solo signals to
the mono and stereo local monitor
outputs with full left, center, right
imaging. This overrides any signals
sent from other sources when ever a
solo is active on the console.
The SOLO switch routes solo signals
to the stereo local monitor outputs
when ever a solo is active on the
console. This overrides any signals
sent from the mono master, stereo
master or tape input.
The MONO master switch routes the
post fader mono master mix to the
stereo local monitor outputs.
The ST master switch routes the post
fader stereo master mix to the stereo
local monitor outputs.
The TAPE switch routes the stereo tape
input to the stereo local monitor
outputs.
The LOCAL MONITOR level control
gives continuous adjustment of all
three local monitor output levels from
The local monitor MUTE switch mutes
the headphone outputs.
The PHONES level control gives
continuous adjustment of the
headphone level from + 10dB to off.
The phones MUTE switch mutes the
headphone outputs.
19