User Manual

34
Probe compensation
2) Press then then and , set the probe calibration signal output
as start , then at the top left corner the square wave screen icon is flashing, indicate square
wave signal is output, see figure 2 to 13;
Picture 2-13 signal output of probe compensation
3) Put the banana plug into multimeter jack, and put the probe, which needs calibration
to the banana head. See picture2-14, press to adjust waveform display or manual
adjustment, if necessary, users can repeat the above steps and observe the waveform,
shown as picture 2-15, 2-16, 2-17.