User Manual

13
Install and replace battery
2.4 Install and replace battery
When using the battery, the upper right corner of the screen displays the battery icon
( ), which indicates the remaining battery power. When battery is in under -voltage
threshold, battery icon flashes which means it should be replaced, if continue use,
oscilloscope will automatic power off. At this moment user should use an external power
adapter. When battery is not full, please plug in power adapter, so the battery in charging
status, If battery is full or use power adapter only, the upper right corner of screen shows
power in-charging icon( ). Turn off channels that are not in use, lower the screen
background brightness and reduce the memory depth or refresh rate to lower power
consumption.
Steps for installing battery
1. Open the bracket, refer to picture 2-6①
2. Put the battery into the compartment and push the battery from bottom up until