User Manual

161
Measure simple signal
5.1Taking simple measurement
Observe the signal waveform in the circuit and connect to the oscilloscope to show signal
quickly; Auto-measure frequency, cycle, the average and peak-peak; the cursor is used to
measure the peak and decay period.
1. Follow these steps to get quick display signal waveform:
1) connect Ch1 to the measured signal;
2) press to switch Ch1 as the current channel(if Ch1 is already current, ignore this
step);
3) press , then Oscilloscope automatically set vertical, horizontal and trigger; Users
can also manually adjust the vertical and horizontal gear until the waveform conforms to
your requirements.
2. Auto-measurement