User Manual

150
I2C bus trigger and decode
Picture 4-17 SPI matching bit settings menu
The method for operation is same as configuration of CAN and frame ID.
Measured signal length is 8 bit; trigger mode matching bit is 11110101, Ch2 connect to CLK,
Ch1 connect to DATA, bus is idle for low level, Please follow these steps for clock rising
samples;
（1） In oscilloscope function mode，press , then press select the trigger
type as serial bus
（2） press to select bus type as SPI
（3） press to enter the bus configuration menu, successively press the CLK of
Ch2, data as Ch1, work mode as SCK low idle state, sample with SCK is edge, data