User Manual

140
CAN bus trigger and decode
to set the ID and the data values. Connect Ch1 to the measured signal, the idle
level is high, the baud rate is 19.2 KB/s.
Please follow these steps to sync- rising edge type
（1） In oscilloscope function mode, press , then press to select
trigger type as serial bus trigger;
（2） Press to select bus type as “LIN”;
（3） Press , then popup bus configuration menu. Successively press
Ch1, idle high, 19.2kb/s, then press to return;
（4） Press , then popup configuration of trigger type, select sync-
rising edge, then press to back.
（5） According signal amplitude to adjust the trigger level, LIN trigger