User Manual

112
Use math menu
Press and to set the channel as dual waveform calculation, signal source can
be Ch1 or Ch2, math operation is shown in the following two waveforms.
Operator
Operation mode
+
Source1 + Source2
_
Source1 - Source2
*
Source1 * Source2
/
Source1 / Source2
Notes：While math waveform displaying on the screen, make sure the waveform will not
extend out of the top or bottom waveform window, if some waveforms are out of screen,
the math waveform operation results may not be correct.
Math waveform Ch1 + Ch2, follow the below steps,
1) Press to enter math menu;
2) Press to select signal source as“Ch1”;