Specifications

Troubleshooting and FAQs
5-5
The following table describes the different LAN bypass triggers and the associated
LED indicator status.
LAN bypass is disabled by default. You can enable the feature through the InterScan
Gateway Security Appliance Preconfiguration console. See
Enabling or Disabling
LAN Bypass and Link State Failover on page 5-6.
Link State Failover
Link state failover is a feature by which, if either the INT or the EXT port stops
functioning, both ports are automatically shut down. This feature is disabled by
default. You can enable it through the Preconfiguration console. For instructions on
enabling or disabling this feature, see
Enabling or Disabling LAN Bypass and Link
State Failover on page 5-6.
TABLE 5-1. LED indicator status
Trigger LED 1 Status LED 2 Status
Software problems or system
rebooting
Yellow OFF
Power cord is plugged in but
device is shutdown
Yellow OFF
Power cord unplugged OFF OFF