Specifications

Preconfiguring InterScan Gateway Security Appliance
4-17
Connecting to the Network
Note: Be sure to preconfigure the appliance before attempting to connect to the network.
To connect the appliance to your network:
Note: After preconfiguration, switch off the device before connecting it to the
network.
1. Connect one end of the Ethernet cable to the INT port and the other end to the
segment of the network that
the appliance will protect (the Protected Network).
2. Connect one end of another Ethernet cable to the EXT port and the other end to
the part of the network that leads to the public network.
3. Power on the device.
Note: InterScan Gateway Security Appliance can handle various interface speeds and
duplex mode network traffic.
Testing for Device Connectivity
Perform either of the following tasks to test whether you have successfully
configured the InterScan Gateway Security Appliance.
To test if the device is configured properly, do one of the following:
Ping the device to verify connectivity
Browse the appliance Web-interface by going to a PC on the protected network
and opening an IE browser to https://(hostname or IPAddress)