Specifications

Preconfiguring InterScan Gateway Security Appliance
4-7
Using the Preconfiguration Console to Set
Device Settings
Preconfiguring the appliance using the preconfiguration console requires the
completion of the following tasks:
1. Interfacing with the Preconfiguration Console on page 4-7
2. Logging On to the Preconfiguration Console on page 4-12
3. Configuring Device Settings on page 4-13
4. Setting the Interface Speed and Duplex Mode on page 4-14
5. Exiting the Preconfiguration Console on page 4-15
Interfacing with the Preconfiguration Console
Designate a local computer to interface with the appliance console port. Use a com-
puter that has a serial port and terminal configuration software such as HyperTerminal
for Windows.
To access the preconfiguration console:
1. Connect one end of the included console cable to the CONSOLE port on the
back panel of the device and the other end to the serial port (COM1, COM2, or
any other available COM port) on the designated local computer. (See
Figure 1-4. Back panel on page 1-8.)
Tip: Trend Micro recommends that you configure HyperTerminal properties
so that the backspace key is set to delete and that you set the emulation
type to VT100J for best display results.