Specifications

Mounting and Basic Deployment
2-15
4. Push the device, while holding the rail release open, into the rack until the front
of the device is flush against the front rack posts.
FIGURE 2-10. The appliance with rail attached
5. Twist the sun screws until tight to prevent the device from sliding in and out of
the rack.
Attaching the Rubber Feet for Freestanding Installation
For freestanding installation, ensure that the device has at least 2-inch (5.08cm) of
clearance on each side to allow for adequate airflow and cooling.
Use the pre-die-cut rubber feet that came with the device for a freestanding
installation. The rubber feet come pre-die-cut on an adhesive sheet. Remove each
rubber foot as needed being careful not to touch the adhesive surface. Stick the
rubber feet to the bottom of the device within 1-inch of each corner.
Thumb screw —used to stabilize
the device in a rack
Rail release—allows
the appliance to be
slid out of cabinet