Installation guide

Trend Micro™ InterScan™ Web Security Virtual Appliance 6.5 Installation Guide
A-12
The Edit ICAP Service name screen appears.
7. Type or select the following information:
a. ICAP version number (that is, 1.0)
b. The service URL, which includes the virus-scanning server host name or IP
address, and the ICAP port number. The default ICAP port number is 1344.
• Response mode:
icap://{ICAP-SERVER-IP}:1344
• Request mode:
icap://{ICAP-SERVER-IP}:1344/REQ-Service
where ICAP-SERVER-IP is the IP address of IWSVA ICAP.
c. The maximum number of connections (ranges from 1-65535). The default
value is 5.
d. The connection timeout, which is the number of seconds the Blue Coat Port
80 Security Appliance waits for replies from the virus-scanning server. The
range is an interval from 60 to 65535. The default timeout is 70 seconds.
e. Choose the type of method supported (response or request modes).
f. Use the default preview size (bytes) of zero (0).
g. Click Sense settings to retrieve settings from the ICAP server
(recommended).
h. To register the ICAP service for health checks, click Register under the
Health Check Options section.
8. Click OK and then click Apply.
Note: You can edit the configured ICAP services. To edit a server configuration again,
select the service and click Edit. The examples used for configuring ICAP for
Blue Coat are based on version 2.1.07. The settings might vary depending on the
version of Blue Coat used.
9. Add a response or request mode policy.
The Visual Policy Manager requires the Java 2 Runtime Environment Standard
Edition v.1.3.1 or later (also known as the Java Runtime or JRE) from Sun™
Microsystems, Inc. If you already installed JRE on your workstation, the Security