Installation guide

Deployment Integration
A-9
• Define the following configuration settings in the [ftp] section of the pni-file:
Integration with an ICAP Device
You can integrate IWSVA on a network that utilizes an ICAP 1.0 compliant cache
server.
Setting up an ICAP 1.0-compliant Cache Server
Configure an ICAP client to communicate with the ICAP server.
• To set up ICAP for NetCache Appliance: on page A-9
• To set up ICAP for the Blue Coat Port 80 Security Appliance: on page A-11
• To set up ICAP for Cisco CE ICAP servers: on page A-15
Setting up ICAP for NetCache Appliances
To set up ICAP for NetCache Appliance:
1. Log on to the NetCache console by opening http://{SERVER-IP}:3132 in a
browser window.
2. Click Setup, and then click ICAP > ICAP 1.0 in the left menu.
3. Click General, and then select Enable ICAP Version 1.0. Click Commit
Changes.
Note: An “icap: This service is not licensed” error message appears
when you have not provided the required ICAP license key for NetCache.
4. Enter an ICAP license key:
•
proxy_mode=dedicated specifies operational mode
•
ftp_server specifies the IP address of the protected FTP
server
•
ftp_server_port specifies the TCP port of the protected server