Installation guide

Trend Micro™ InterScan™ Web Security Virtual Appliance 6.5 Installation Guide
4-6
Migrating from IWSVA 6.5 to Another IWSVA 6.5
Note: IWSVA 6.5 does not support migration from another language version of IWSVA 6.5.

A full migration from one IWSVA 6.5 device to another IWSVA 6.5 device is only
supported if both devices are configured in standalone mode.

To perform a full migration, make sure the hardware configuration and deployment
mode are the same on both IWSVA machines. Trend Micro also recommends you
configure both machines to use the same IP address to prevent unexpected behavior
after a full migration. 

If the IP address information in the backup file is different from the IP address of the
IWSVA machine to which you want to import the file, the migration results screen
will not display. In this case, you can view the migration results in the Audit Log
screen. 

After a full migration, if the separate management interface is enabled on the source
IWSVA machine, you must use the management IP address of the source IWSVA
machine to access the Web console on the target IWSVA 6.5 machine.
Procedure:
1. Open the Web console of the source IWSVA 6.5 machine and select
Administration > Config Backup/Restore. Then, click Export to back up the
configuration.
The screen displays a progress bar. When the export process is finished, a result
page displays the status. If the configuration export process is successful, IWSVA
opens a dialog box to prompt you to save the configuration file to a local disk. Save
the file to a local drive on your computer.
2. Open the Web console of the target IWSVA 6.5 machine and then click
Administration > Config Backup/Restore from the main menu.
3. Click Browse to select a backup file and then click Import.
Note: If you are migrating from a source IWSVA 6.5 to a target IWSVA 6.5, and both
devices are configured in standalone mode, you can choose to perform a full or
partial migration. Otherwise, by default, only a partial migration is performed.