Installation guide

Trend Micro™ InterScan™ Web Security Virtual Appliance 6.5 Installation Guide
4-2
About Migration
InterScan Web Security Virtual Appliance (IWSVA) 6.5 supports both full and partial
migration. Use full migration to restore the system and application settings or to apply
current configuration to an IWSVA replacement machine. Perform a partial migration if
you want to replace policy and application level configurations.
WARNING! IWSVA 6.5 does not support migration from another language version of
IWSVA 6.0 SP1, IWSVA 6.0, IWSVA 5.6, IWSVA 5.5, IWSVA 5.1 SP1,
IWSVA 5.1, IWSVA 5.0, IWSVA 3.1, or IWSS 3.1 Linux/Windows 

Before you perform a full migration, make sure the hardware configura-
tion and deployment mode are the same on both the source and target
IWSVA 6.5 machines. 

Trend Micro recommends that you configure the target IWSVA 6.5
machine to use the same IP address as in the backup configuration file
(exported from the source IWSVA 6.5 machine) to prevent unexpected
behavior after a full migration. 

Do NOT connect both IWSVA 6.5 machines to the network simultane-
ously. Only one IWSVA 6.5 machine should be connected at a time.
The configuration and policy information for the following IWSVA products can be
migrated to IWSVA:
•IWSVA 5.6
•IWSVA 6.0
•IWSVA 6.0 SP1
•IWSVA 6.5
Important Notes
• You can export IWSVA configuration to a backup file. Export information includes
both system level and application level configuration settings.
•Use the Config Backup & Restore page in the Web console to import the backup
file containing the IWSVA 6.5 configuration. A screen displays to prompt you to
select either full migration or partial migration.