User Manual
Table Of Contents
- About This Manual
- Copyright
- Proprietary Material
- Quality Certification
- Regulatory Status
- Conventions
- Symbols Used
- Warranty Information
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators, and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the STRATA TX Screens
- 3.5 TXU and/or TCU Monitoring Operations
- 3.5.1 Using the Monitor Screens in MPEG Output Mode
- 3.5.2 Using the Monitor Screens in Ext IF Input Mode
- 3.5.3 Using the Monitor Screens in COFDM - IF Mode
- 3.5.4 Using the Monitor Screens in COFDM ASI In Mode
- 3.5.5 Using the Monitor Screens in Analog - IF Mode
- 3.5.6 Using the Monitor Screens in DVB-S Mode
- 3.6 TXU and/or TCU Control Operations
- 3.7 Front Panel vs. STRATA TX Configurator Settings
- Table 3-1: Front Panel vs. Configurator Settings
- Troubleshooting
- Channels & Frequencies
- A.1 Appendix Overview
- A.2 Initial Factory Presets
- A.2.1 3.4 to 3.8 GHz Channel Plan
- A.2.2 4.4 to 5.0 GHz Channel Plan
- A.2.3 6.4 to 7.1 GHz Channel Plan
- A.2.4 6.9 to 7.5 GHz Channel Plan
- A.2.5 7.4 to 8.0 GHz Channel Plan
- A.2.6 7.8 to 8.5 GHz Channel Plan
- A.2.7 8.2 to 8.9 GHz Channel Plan
- A.2.8 10.0 to 10.7 GHz Channel Plan
- A.2.9 10.5 to 11.2 GHz Channel Plan
- A.2.10 10.8 to 11.5 GHz Channel Plan
- A.2.11 12.7 to 13.25 GHz Channel Plan
- Glossary
- Specifications
Troubleshooting 4-4STRATA TX Operator’s Guide/Tech Ref Manual
Table 4-3: Primary Error Codes
Error Code Meaning Suggested Operator Action Suggested Technical Staff Action
Status Errors
(Some part of System is reporting an abnormal condition.)
E020 TXU IF Fault • Verify condition of all cable
connections.
• Contact technical staff.
Call MRC Technical Support.
E021 TXU RF Fault • Verify condition of all cable
connections.
• Contact technical staff.
Call MRC Technical Support.
E0E0 FMT Video PLL Unlocked Note - This error will appear only if the TX
System contains the FMT option.
• Contact technical staff.
• Verify video input is at the correct
level.
• Call MRC Technical Support.
E0E1 FMT Audio 1 PLL Unlocked Note - These errors will appear only if the
TX System contains the FMT option.
• Check FMT settings using Monitor
Screens and Command Screens.
Settings must match transmitter
settings.
• Contact technical staff.
• Use STRATA TX Configuration Utility
to check FMT settings. Be sure all
settings match the transmitter
settings.
• Use STRATA TX Configuration Utility
to reprogram all the settings in the
radio.
• If problem persists, possible
hardware failure. Call MRC Technical
Support.
E0E2 FMT Audio 2 PLL Unlocked
E0E3 FMT Audio 3 PLL Unlocked
E0E4 FMT Audio 4 PLL Unlocked