User Manual
Table Of Contents
- About This Manual
- Copyright
- Proprietary Material
- Quality Certification
- Regulatory Status
- Conventions
- Symbols Used
- Warranty Information
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators, and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the STRATA TX Screens
- 3.5 TXU and/or TCU Monitoring Operations
- 3.5.1 Using the Monitor Screens in MPEG Output Mode
- 3.5.2 Using the Monitor Screens in Ext IF Input Mode
- 3.5.3 Using the Monitor Screens in COFDM - IF Mode
- 3.5.4 Using the Monitor Screens in COFDM ASI In Mode
- 3.5.5 Using the Monitor Screens in Analog - IF Mode
- 3.5.6 Using the Monitor Screens in DVB-S Mode
- 3.6 TXU and/or TCU Control Operations
- 3.7 Front Panel vs. STRATA TX Configurator Settings
- Table 3-1: Front Panel vs. Configurator Settings
- Troubleshooting
- Channels & Frequencies
- A.1 Appendix Overview
- A.2 Initial Factory Presets
- A.2.1 3.4 to 3.8 GHz Channel Plan
- A.2.2 4.4 to 5.0 GHz Channel Plan
- A.2.3 6.4 to 7.1 GHz Channel Plan
- A.2.4 6.9 to 7.5 GHz Channel Plan
- A.2.5 7.4 to 8.0 GHz Channel Plan
- A.2.6 7.8 to 8.5 GHz Channel Plan
- A.2.7 8.2 to 8.9 GHz Channel Plan
- A.2.8 10.0 to 10.7 GHz Channel Plan
- A.2.9 10.5 to 11.2 GHz Channel Plan
- A.2.10 10.8 to 11.5 GHz Channel Plan
- A.2.11 12.7 to 13.25 GHz Channel Plan
- Glossary
- Specifications
Routine Operation 3-28STRATA TX Operator’s Guide/Tech Ref Manual
3.6 TXU and/or TCU Control
Operations
This section describes how to configure your STRATA TX
System using the front panel control switch. Turning the front
panel control switch counterclockwise on either the TXU or TCU
controls transmitter functions including changing Presets,
changing RF channel assignments, setting RF attenuation
levels, and activation of DC power from a TCU to a separately
located TXU, or from a TXU to a separately located TCU.
Settings may be changed on a standalone TCU, a standalone
TXU, or a TXU and TCU TX System.
For a summary of settings that can be changed using the front
panel control switch and which are made using the STRATA TX
Configuration Utility software, see “Front Panel vs. STRATA TX
Configurator Settings” on page 3-35.
Here are the tasks described:
Refer to Figure 3-24 on page 3-29 for the Control Menu Map.
Topic Page
Changing a Preset 3-30
Setting a Channel 3-31
Setting Power Output 3-32
Controlling TCU to TXU
DC Power on Coax
3-33