User Manual
Table Of Contents
- About This Manual
- Copyright
- Proprietary Material
- Quality Certification
- Regulatory Status
- Conventions
- Symbols Used
- Warranty Information
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators, and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the STRATA TX Screens
- 3.5 TXU and/or TCU Monitoring Operations
- 3.5.1 Using the Monitor Screens in MPEG Output Mode
- 3.5.2 Using the Monitor Screens in Ext IF Input Mode
- 3.5.3 Using the Monitor Screens in COFDM - IF Mode
- 3.5.4 Using the Monitor Screens in COFDM ASI In Mode
- 3.5.5 Using the Monitor Screens in Analog - IF Mode
- 3.5.6 Using the Monitor Screens in DVB-S Mode
- 3.6 TXU and/or TCU Control Operations
- 3.7 Front Panel vs. STRATA TX Configurator Settings
- Table 3-1: Front Panel vs. Configurator Settings
- Troubleshooting
- Channels & Frequencies
- A.1 Appendix Overview
- A.2 Initial Factory Presets
- A.2.1 3.4 to 3.8 GHz Channel Plan
- A.2.2 4.4 to 5.0 GHz Channel Plan
- A.2.3 6.4 to 7.1 GHz Channel Plan
- A.2.4 6.9 to 7.5 GHz Channel Plan
- A.2.5 7.4 to 8.0 GHz Channel Plan
- A.2.6 7.8 to 8.5 GHz Channel Plan
- A.2.7 8.2 to 8.9 GHz Channel Plan
- A.2.8 10.0 to 10.7 GHz Channel Plan
- A.2.9 10.5 to 11.2 GHz Channel Plan
- A.2.10 10.8 to 11.5 GHz Channel Plan
- A.2.11 12.7 to 13.25 GHz Channel Plan
- Glossary
- Specifications
Routine Operation 3-21STRATA TX Operator’s Guide/Tech Ref Manual
Operation Only)
The options displayed on the Monitor Screens are in bold fonts.
Once the STRATA TX System is set up and powered up, you will
be able to check its configuration and monitor its operation.
The following sections describe how to use the Monitor Screens
and how to monitor the quality of the microwave link.
Here are the tasks described:
Topic Page
Using the Monitor Screens in
MPEG Output Mode
3-21
Using the Monitor Screens in Ext
IF Input Mode
3-23
Using the Monitor Screens in
COFDM - IF Mode
3-24
Using the Monitor Screens in
COFDM ASI In Mode
3-25
Using the Monitor Screens in
Analog - IF Mode
3-26
Using the Monitor Screens in DVB-
S Mode
3-27
3.5.1 Using the Monitor Screens in MPEG Output
Mode
When the STRATA TX System Preset selected is operating in
the MPEG Output mode, a DVB ASI transport stream is
supplied to the signal output connector and the monitor output
connector. The MPEG Output mode is only available when the
TCU is operated in a standalone configuration.
See Figure 3-18 on page 3-22 for the MPEG Output Monitor
Menu Map.