User Manual
Table Of Contents
- About This Manual
- Copyright
- Proprietary Material
- Quality Certification
- Regulatory Status
- Conventions
- Symbols Used
- Warranty Information
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators, and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the STRATA TX Screens
- 3.5 TXU and/or TCU Monitoring Operations
- 3.5.1 Using the Monitor Screens in MPEG Output Mode
- 3.5.2 Using the Monitor Screens in Ext IF Input Mode
- 3.5.3 Using the Monitor Screens in COFDM - IF Mode
- 3.5.4 Using the Monitor Screens in COFDM ASI In Mode
- 3.5.5 Using the Monitor Screens in Analog - IF Mode
- 3.5.6 Using the Monitor Screens in DVB-S Mode
- 3.6 TXU and/or TCU Control Operations
- 3.7 Front Panel vs. STRATA TX Configurator Settings
- Table 3-1: Front Panel vs. Configurator Settings
- Troubleshooting
- Channels & Frequencies
- A.1 Appendix Overview
- A.2 Initial Factory Presets
- A.2.1 3.4 to 3.8 GHz Channel Plan
- A.2.2 4.4 to 5.0 GHz Channel Plan
- A.2.3 6.4 to 7.1 GHz Channel Plan
- A.2.4 6.9 to 7.5 GHz Channel Plan
- A.2.5 7.4 to 8.0 GHz Channel Plan
- A.2.6 7.8 to 8.5 GHz Channel Plan
- A.2.7 8.2 to 8.9 GHz Channel Plan
- A.2.8 10.0 to 10.7 GHz Channel Plan
- A.2.9 10.5 to 11.2 GHz Channel Plan
- A.2.10 10.8 to 11.5 GHz Channel Plan
- A.2.11 12.7 to 13.25 GHz Channel Plan
- Glossary
- Specifications
Routine Operation 3-12STRATA TX Operator’s Guide/Tech Ref Manual
Figure 3-8: Attaching Quick Release to Tripod
3. If you have both an TXU and a TCU, be sure they are
connected to each other via coaxial cable.
If you are unsure of the connections, refer to the
“Installation” Chapter on page 6-1 (part of the STRATA
TX System Technical Reference Manual only).
4. Connect the STRATA TXU (and TCU, if present) to DC
power of the correct voltage and polarity.
If you’re using a STRATA ACU, connect the AC input
to AC power and connect the DC output to the TXU
and TCU.
If you are unsure of the power requirements or the
connections, refer to the “Installation” Chapter on
Quick Release
Tripod
page 6-1 (part of the STRATA TX System Technical
Reference Manual only).
5. Connect the TXU (or TCU) inputs to your audio and
video equipment.
Figure 3-9: Complete Tripod Installation
3.3.3 Powering the STRATA TX System
The STRATA TX System will be in one of two configurations
which provide different options for controlling application of DC
power between units. Model variations are as follows:
Universal
Mounting
Brackets
Antenna
(2 Options
Shown)
Quick
Release
TXU
TCU
ACU
Mounting
Plate
Tripod
(Typical)