User Manual
Routine Operation 3-19STRATA TX Operator’s Guide/Tech Ref Manual
installed firmware, and finally the Main Screen.
Some typical screens are shown in Figure 3-16. The
exact screens will vary depending on installed
hardware.
- The TXU will typically power up using the last settings
in use when power was turned off.
- If the TXU does not power up normally, refer to the
“Troubleshooting” Chapter on page 4-1.
Figure 3-16: Typical TXU Power Up Screens - Co-Located
TXU and TCU
Power Down
1. Set the TXU PWR switch to 0 (off).
2. Set the TCU PWR switch to 0 (off).
3. If the TCU/TXU is powered from the optional ACU, set
the ACU power switch to 0 (off).
If the TCU/TXU is powered from a source other than
an ACU, turn that power source off.
STRATA TX
V 0.1.1
Preset 1
0.00W
Firmware
Version
Main Screen
3.4 Using the STRATA TX Screens
As you use the STRATA TX System, you will interact extensively
with the TXU and/or TCU screens. Following are some points to
make this easier.
Main Screen The Main Screen is your starting point for
navigating through the Monitor and Control screens. The Main
Screen provides the current values of the Preset selected and
the selected Preset output power level.
When the STRATA TX System completes its power-up
sequence, it will display the Main Screen. A typical Main Screen
is shown in Figure 3-17.
Figure 3-17: Typical STRATA TX Main Screen
Accessing the Main Screen You can access the Main Screen
at any time by scrolling to the end of the screens you are viewing
(either Monitor or Control). Your next click of the Control Switch
will bring up the Main Screen.
Accessing the Monitor Screen You can access the Monitor
Screens at any time by turning the Control Switch clockwise
(cw).
Accessing the Control Screen You can access the Control
Screen at any time by turning the Control Switch counter-
clockwise (ccw).
Preset 3
. W
Currently
Selected
Preset
Output Power
Level