User Manual
Table Of Contents
- Strata Transmitter
- Operations Guide
- Theory of Operation
- Command and Control Power Supply
- MPEG/COFDM Encoder/Modulator
- FMT
- TCU
- TXU
- HPU
- TCU/TXU Front Panel Control Settings
- Notes:
- In the case of digital audio connections, note that the GND (ground) connection is common to two audio circuits as opposed to the connections used for standard analog audio circuits. In the case of digital audio circuits then, a single XLR connector sup
- Strata TX Digital and Analog Audio Options
- Strata Power Cables
- MRC 907386-1 COFDM/MPEG Encoder PWB Layout
Strata Operations Guide
-
17 -
Step-by-Step Procedure
Use the following Strata configuration procedure when verifying or configuring the Strata TX system
using the Strata TX Configurator software over a local or remote serial data link.
1. Install the Strata Configurator software per instructions supplied with the software. This software is
designed to operate properly on Windows 32 bit operating systems, e.g., Windows 98/NT/2000/ or
XP operating systems.
2. Connect the PC serial port to the TCU or TXU per Figure 5. above. Apply the appropriate DC power
to the Strata TX radio system and operate the front panel power switch(s) to ON.
3. Start the Strata Configurator application. You should see the following main menu appear:
4. Click on the “Connect to Radio” control. The following dialog is presented.