User Manual
Table Of Contents
- Strata Transmitter
- Operations Guide
- Theory of Operation
- Command and Control Power Supply
- MPEG/COFDM Encoder/Modulator
- FMT
- TCU
- TXU
- HPU
- TCU/TXU Front Panel Control Settings
- Notes:
- In the case of digital audio connections, note that the GND (ground) connection is common to two audio circuits as opposed to the connections used for standard analog audio circuits. In the case of digital audio circuits then, a single XLR connector sup
- Strata TX Digital and Analog Audio Options
- Strata Power Cables
- MRC 907386-1 COFDM/MPEG Encoder PWB Layout
Strata Operations Guide
-
16 -
TCU “Signal In” Connection – not DC isolated
Note:
To minimize the potential for damaging the TCU signal input circuitry, the “Signal Out” jack rear panel
BNC connector has been changed to a TNC type connector. Users are cautioned not to use a TNC-to-
BNC adapter on the TCU “Signal Out” jack to circumvent this protection feature. Each Strata TX system
that includes TXU and TCU modules is shipped with a short BNC-to-TNC coaxial cable assembly for
interconnecting TXU and TCU modules. For those system applications that require separating the TXU
and TCU over longer distances, users are advised to use a BNC “barrel” adapter on the BNC end of the
supplied coaxial cable assembly.