User Manual

3-2 Operating the PTX-PRO PTX-PRO User and Technical Manual
3.3 Monitoring PTX-PRO Operations
Review Monitor screens by turning the Control switch clockwise. The sequence of screens
depends on the mode.
• Analog IF mode routes a 70 MHz IF signal through the transmitter to the Signal input
connector.
• ASI In mode supplies an ASI stream to the RF output monitor connectors.
• COFDM mode supplies a 70 MHz CODFM IF to the RF output and monitor connectors.
• Ext. IF mode supplies a 70 MHz IF input signal to the Signal Input connector of the
transmitter.
• LMS-T mode uses a single carrier modulator and supplies a configurable LMV-S signal
to the RF output and monitor connectors.
The following table shows the Monitor screen sequences of each mode.
Monitor Menu Sequence (Clockwise)
Analog IF ASI In CODFM Mode EXT IF Mode LMS-T Mode
12712.500MHz
0.00W C 1
12712.500MHz
0.00W C 1
12712.500MHz
0.00W C 1
12712.500MHz
0.00W C 1
12712.500MHz
0.00W C 1
TX Attn
0.0db
TX Attn
0.0db
TX Attn
0.0db
TX Attn
0.0db
TX Attn
0.0db
Band
13 GHz
Band
13 GHz
Band
13 GHz
Band
13 GHz
Band
13 GHz
Mode
Analog - IF
Mode
ASI/SDI In
Mode
COFDM
Mode
EXT IF Input
Mode
LMS-T
Audio #1 ON
Pre 4.83MHz
QPSK 8MHz
ASI 18.096Mb
FE1/2 GI1/32
64QAM 8MHz
ASI 18.096Mb
FE1/2 GI1/32
No Errors QPSK 10MHz
ASI 18.096Mb
FE1/2 GI1/32
Audio #2 ON
Pre 5.20MHz
IF CW OFF NTSC NoPdstl
Vid In 4:2:0
NTSC NoPdstl
Vid In 4:2:0
Audio #3 ON
Pre 5.80MHz
No Errors Video Delay
Normal
Video Delay
Normal
Audio #4 ON
Pre 6.20MHz
MPEG AudioA
AESEBU Streo
MPEG AudioA
AESEBU Streo
VID Dev 4MHz
PAL/No Video
MPEG AudioB
AESEBU Streo
MPEG AudioB
AESEBU Streo
IF CW OFF No Errors No Errors
No Errors