User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the Display Screens
- 3.5 PTX-PRO Monitoring Operations
- 3.6 PTX-PRO Control Operations
- 3.7 Front Panel vs. Configurator Settings
- Troubleshooting
- Advanced Operation
- 5.1 Chapter Overview
- 5.2 Before You Begin
- 5.3 Create or Update a Configuration
- 5.3.1 Using the Configurator Software
- 5.3.2 Determine Licensed Options
- 5.3.3 Create New Configuration On-Line
- 5.3.4 Load and Modify Configuration Settings On- Line
- Figure 5-7: Load and Modify Configuration Settings On-Line - Sheet 1 of 5
- Figure 5-8: Load and Modify Configuration Settings On-Line - Sheet 2 of 5
- Figure 5-9: Load and Modify Configuration Settings On-Line - Sheet 3 of 5
- Figure 5-10: Load and Modify Configuration Settings On-Line - Sheet 4 of 5
- Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
- 5.3.5 Load Configuration File into Radio On-Line
- 5.3.6 Change Preset Names in On-Line Mode
- 5.3.7 Create Channel Plan Offline
- 5.3.8 Modify Channel Plan in Offline Mode
- 5.3.9 Load and Modify a Channel Plan On-Line
- 5.3.10 Load Channel Plan File into Radio On-Line
- 5.3.11 Add Licensed Option
- Installation
- 6.1 Chapter Overview
- 6.2 Unpacking
- 6.3 Initial Inspection
- 6.4 Damage in Shipment
- 6.5 Mounting and Cabling
- 6.6 Power Connections
- 6.7 Grounding
- 6.8 Audio Connections
- 6.9 Signal Connections
- 6.10 Data Connections
- 6.11 Powering Up
- 6.12 Configurator Software Installation
- 6.13 Product Modifications
- Replacement Parts
- Theory of Operation
- Index
Installation 6-5PTX-PRO User and Technical Manual
Figure 6-5: Complete Tripod Installation - Typical
6.6 Power Connections
6.6.1 Power Requirements
The PTX-PRO has the following power requirements, depending
upon the power option utilized.
Supply Voltage: +11.0 to +36 Volts DC
90 to 264 VAC, 50/60 Hz
Quick Release
Mount
PTX-PRO (Typical)
Antenna Lock
Plate
Antenna
(2 Options
Shown)
Tripod
Power Consumption: 50 watts nominal
6.6.2 Power Supply and Distribution
AC or DC power is supplied externally, from an external power
source.
CAUTION
Avoid possible equipment damage. If you
are using a DC power source for your PTX-
PRO, do not exceed 36 volts DC input
power.
Power is distributed to the PTX-PRO through the front panel
PWR connector on the PTX-PRO.
CAUTION
To avoid possible equipment damage, turn
off DC Power on the coax before connecting
any test equipment.
Panel Power Connections The PTX-PRO power connector is
located on the front panel. The mating connector that plugs into
this panel connector is described below.
Manufacturer: ITT Cannon
Part Number KPTR06F14-12SX
Description: 12-Pin, Female, Plug
Manufacturer: Amphenol
Part Number PT06E14-12SX
Description: 12-Pin, Female, Plug