User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the Display Screens
- 3.5 PTX-PRO Monitoring Operations
- 3.6 PTX-PRO Control Operations
- 3.7 Front Panel vs. Configurator Settings
- Troubleshooting
- Advanced Operation
- 5.1 Chapter Overview
- 5.2 Before You Begin
- 5.3 Create or Update a Configuration
- 5.3.1 Using the Configurator Software
- 5.3.2 Determine Licensed Options
- 5.3.3 Create New Configuration On-Line
- 5.3.4 Load and Modify Configuration Settings On- Line
- Figure 5-7: Load and Modify Configuration Settings On-Line - Sheet 1 of 5
- Figure 5-8: Load and Modify Configuration Settings On-Line - Sheet 2 of 5
- Figure 5-9: Load and Modify Configuration Settings On-Line - Sheet 3 of 5
- Figure 5-10: Load and Modify Configuration Settings On-Line - Sheet 4 of 5
- Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
- 5.3.5 Load Configuration File into Radio On-Line
- 5.3.6 Change Preset Names in On-Line Mode
- 5.3.7 Create Channel Plan Offline
- 5.3.8 Modify Channel Plan in Offline Mode
- 5.3.9 Load and Modify a Channel Plan On-Line
- 5.3.10 Load Channel Plan File into Radio On-Line
- 5.3.11 Add Licensed Option
- Installation
- 6.1 Chapter Overview
- 6.2 Unpacking
- 6.3 Initial Inspection
- 6.4 Damage in Shipment
- 6.5 Mounting and Cabling
- 6.6 Power Connections
- 6.7 Grounding
- 6.8 Audio Connections
- 6.9 Signal Connections
- 6.10 Data Connections
- 6.11 Powering Up
- 6.12 Configurator Software Installation
- 6.13 Product Modifications
- Replacement Parts
- Theory of Operation
- Index
Advanced Operation 5-21PTX-PRO User and Technical Manual
5.3.11 Add Licensed Option
The flowchart required to add new licensed options to your PTX-PRO
is contained in Figure 5-18. The license required to add a new licensed
feature must be obtained from MRC prior to performing this procedure.
Figure 5-18: Add Licensed Option
MRC Configurator Icon
Main Page
Radio Control
COM Port Menu
Select COM port
required
Connect
Radio Mode,
MPEG, COFDM,
LMS-T, Channel
Plan, and
Licensing Tabs
are displayed
Licensing Tab
Licensed
Features
All current
licensed features
are listed
Refresh
New Licensed
Feature is listed
in Licensed
column
MPEG
Information
Firmware Number
Current firmware
revision is listed
License Key
Enter license key
obtained from
MRC in text box
Serial Number
Serial number of
software module
is listed
Set Key
Select Set Key
option button to
enable license
Licensed
Features
Disconnect
Close
Configurator
window
Radio ControlMain Tab