User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the Display Screens
- 3.5 PTX-PRO Monitoring Operations
- 3.6 PTX-PRO Control Operations
- 3.7 Front Panel vs. Configurator Settings
- Troubleshooting
- Advanced Operation
- 5.1 Chapter Overview
- 5.2 Before You Begin
- 5.3 Create or Update a Configuration
- 5.3.1 Using the Configurator Software
- 5.3.2 Determine Licensed Options
- 5.3.3 Create New Configuration On-Line
- 5.3.4 Load and Modify Configuration Settings On- Line
- Figure 5-7: Load and Modify Configuration Settings On-Line - Sheet 1 of 5
- Figure 5-8: Load and Modify Configuration Settings On-Line - Sheet 2 of 5
- Figure 5-9: Load and Modify Configuration Settings On-Line - Sheet 3 of 5
- Figure 5-10: Load and Modify Configuration Settings On-Line - Sheet 4 of 5
- Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
- 5.3.5 Load Configuration File into Radio On-Line
- 5.3.6 Change Preset Names in On-Line Mode
- 5.3.7 Create Channel Plan Offline
- 5.3.8 Modify Channel Plan in Offline Mode
- 5.3.9 Load and Modify a Channel Plan On-Line
- 5.3.10 Load Channel Plan File into Radio On-Line
- 5.3.11 Add Licensed Option
- Installation
- 6.1 Chapter Overview
- 6.2 Unpacking
- 6.3 Initial Inspection
- 6.4 Damage in Shipment
- 6.5 Mounting and Cabling
- 6.6 Power Connections
- 6.7 Grounding
- 6.8 Audio Connections
- 6.9 Signal Connections
- 6.10 Data Connections
- 6.11 Powering Up
- 6.12 Configurator Software Installation
- 6.13 Product Modifications
- Replacement Parts
- Theory of Operation
- Index
Advanced Operation 5-20PTX-PRO User and Technical Manual
5.3.10 Load Channel Plan File into Radio On-Line
The flowchart required to load a channel plan from a file on your PC
into your PTX-PRO in the on-line mode is contained in Figure 5-17.
Figure 5-17: Load Channel Plan into Radio in On-Line Mode
MRC Configurator Icon
Main Page Channel Plan Tab
Read Bands
from File
Load Channel
Plan
Configuration
File window
Select file
required
Selected file is
loaded into radio
Radio Control
COM Port Menu
Select COM port
required
Connect
Radio Mode,
MPEG, COFDM,
LMS-T, Channel
Plan, and
Licensing Tabs
are displayed
Disconnect
Close
Configurator
window
Radio ControlMain Tab
Program Current
Band to Radio
Program All
Bands to Radio
Orr
The High Band
(13 GHz) channel
plan is loaded
into the radio
And/Orr
The High Band
(13 GHz) channel
plan is loaded
into the radio