User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the Display Screens
- 3.5 PTX-PRO Monitoring Operations
- 3.6 PTX-PRO Control Operations
- 3.7 Front Panel vs. Configurator Settings
- Troubleshooting
- Advanced Operation
- 5.1 Chapter Overview
- 5.2 Before You Begin
- 5.3 Create or Update a Configuration
- 5.3.1 Using the Configurator Software
- 5.3.2 Determine Licensed Options
- 5.3.3 Create New Configuration On-Line
- 5.3.4 Load and Modify Configuration Settings On- Line
- Figure 5-7: Load and Modify Configuration Settings On-Line - Sheet 1 of 5
- Figure 5-8: Load and Modify Configuration Settings On-Line - Sheet 2 of 5
- Figure 5-9: Load and Modify Configuration Settings On-Line - Sheet 3 of 5
- Figure 5-10: Load and Modify Configuration Settings On-Line - Sheet 4 of 5
- Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
- 5.3.5 Load Configuration File into Radio On-Line
- 5.3.6 Change Preset Names in On-Line Mode
- 5.3.7 Create Channel Plan Offline
- 5.3.8 Modify Channel Plan in Offline Mode
- 5.3.9 Load and Modify a Channel Plan On-Line
- 5.3.10 Load Channel Plan File into Radio On-Line
- 5.3.11 Add Licensed Option
- Installation
- 6.1 Chapter Overview
- 6.2 Unpacking
- 6.3 Initial Inspection
- 6.4 Damage in Shipment
- 6.5 Mounting and Cabling
- 6.6 Power Connections
- 6.7 Grounding
- 6.8 Audio Connections
- 6.9 Signal Connections
- 6.10 Data Connections
- 6.11 Powering Up
- 6.12 Configurator Software Installation
- 6.13 Product Modifications
- Replacement Parts
- Theory of Operation
- Index
Advanced Operation 5-18PTX-PRO User and Technical Manual
5.3.8 Modify Channel Plan in Offline Mode
The flowchart required to modify a channel plan contained in a file on
your PC is contained in Figure 5-15.
Figure 5-15: Modify Channel Plan in Offline Mode
MRC Configurator Icon
Main Page Channel Plan Tab
Center
Review and
modify center
frequency for
each channel, as
required
Close
Configurator
window
Start Offline
Programming
Offset +
Review and
modify plus offset
frequency for
channel 1 thru
21, as required
Offset -
Review and
modify minus
offset frequency
for channel 2 thru
22, as required
Offline
Programming
Radio Pull-Down
Menu
Select PTX-PRO
Dual Band
Save Bands to
File
Read Bands
from File
Load Channel
Plan
Configuration
File window
Open file required
Channel
frequencies are
displayed for all
channels and
bands, as
required
Radio Mode,
MPEG, COFDM,
LMS-T, FMT,
Channel Plan,
and Licensing
tabs appear
Save
Configuration
File window
Save file
Low Band Pull-
Down Menu
Select <Low
Band Disabled>
option
High Band Pull-
Down Menu
Select 13 GHz
(12.7 – 13.25)
option