User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the Display Screens
- 3.5 PTX-PRO Monitoring Operations
- 3.6 PTX-PRO Control Operations
- 3.7 Front Panel vs. Configurator Settings
- Troubleshooting
- Advanced Operation
- 5.1 Chapter Overview
- 5.2 Before You Begin
- 5.3 Create or Update a Configuration
- 5.3.1 Using the Configurator Software
- 5.3.2 Determine Licensed Options
- 5.3.3 Create New Configuration On-Line
- 5.3.4 Load and Modify Configuration Settings On- Line
- Figure 5-7: Load and Modify Configuration Settings On-Line - Sheet 1 of 5
- Figure 5-8: Load and Modify Configuration Settings On-Line - Sheet 2 of 5
- Figure 5-9: Load and Modify Configuration Settings On-Line - Sheet 3 of 5
- Figure 5-10: Load and Modify Configuration Settings On-Line - Sheet 4 of 5
- Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
- 5.3.5 Load Configuration File into Radio On-Line
- 5.3.6 Change Preset Names in On-Line Mode
- 5.3.7 Create Channel Plan Offline
- 5.3.8 Modify Channel Plan in Offline Mode
- 5.3.9 Load and Modify a Channel Plan On-Line
- 5.3.10 Load Channel Plan File into Radio On-Line
- 5.3.11 Add Licensed Option
- Installation
- 6.1 Chapter Overview
- 6.2 Unpacking
- 6.3 Initial Inspection
- 6.4 Damage in Shipment
- 6.5 Mounting and Cabling
- 6.6 Power Connections
- 6.7 Grounding
- 6.8 Audio Connections
- 6.9 Signal Connections
- 6.10 Data Connections
- 6.11 Powering Up
- 6.12 Configurator Software Installation
- 6.13 Product Modifications
- Replacement Parts
- Theory of Operation
- Index
Advanced Operation 5-17PTX-PRO User and Technical Manual
5.3.7 Create Channel Plan Offline
The flowchart required to create new channel plans in the offline
mode is contained in Figure 5-14.
Figure 5-14: Create Channel Plan Offline
MRC Configurator Icon
Main Page Channel Plan Tab
Center
Review and
modify center
frequency for
each channel, as
required
Low Band Pull-
Down Menu
Select <Low
Band Disabled>
option
Close
Configurator
window
Start Offline
Programming
Offset +
Review and
modify plus offset
frequency for
channel 1 thru
21, as required
Offset -
Review and
modify minus
offset frequency
for channel 2 thru
22, as required
Offline
Programming
Radio Pull-Down
Menu
Select PTX-PRO
Dual Band
Save Bands to
File
Radio Mode,
MPEG, COFDM,
LMS-T, FMT,
Channel Plan,
and Licensing
tabs appear
Save
Configuration
File window
Save file
High Band Pull-
Down Menu
Select 13 GHz
(12.7 – 13.25)
option