User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the Display Screens
- 3.5 PTX-PRO Monitoring Operations
- 3.6 PTX-PRO Control Operations
- 3.7 Front Panel vs. Configurator Settings
- Troubleshooting
- Advanced Operation
- 5.1 Chapter Overview
- 5.2 Before You Begin
- 5.3 Create or Update a Configuration
- 5.3.1 Using the Configurator Software
- 5.3.2 Determine Licensed Options
- 5.3.3 Create New Configuration On-Line
- 5.3.4 Load and Modify Configuration Settings On- Line
- Figure 5-7: Load and Modify Configuration Settings On-Line - Sheet 1 of 5
- Figure 5-8: Load and Modify Configuration Settings On-Line - Sheet 2 of 5
- Figure 5-9: Load and Modify Configuration Settings On-Line - Sheet 3 of 5
- Figure 5-10: Load and Modify Configuration Settings On-Line - Sheet 4 of 5
- Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
- 5.3.5 Load Configuration File into Radio On-Line
- 5.3.6 Change Preset Names in On-Line Mode
- 5.3.7 Create Channel Plan Offline
- 5.3.8 Modify Channel Plan in Offline Mode
- 5.3.9 Load and Modify a Channel Plan On-Line
- 5.3.10 Load Channel Plan File into Radio On-Line
- 5.3.11 Add Licensed Option
- Installation
- 6.1 Chapter Overview
- 6.2 Unpacking
- 6.3 Initial Inspection
- 6.4 Damage in Shipment
- 6.5 Mounting and Cabling
- 6.6 Power Connections
- 6.7 Grounding
- 6.8 Audio Connections
- 6.9 Signal Connections
- 6.10 Data Connections
- 6.11 Powering Up
- 6.12 Configurator Software Installation
- 6.13 Product Modifications
- Replacement Parts
- Theory of Operation
- Index
Advanced Operation 5-14PTX-PRO User and Technical Manual
Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
Channel Plan Tab
Center
Modify center
frequency for
each channel, as
required
Currently
Selected Band
Observe the
Currently
Selected Band
indicates High
Band (13 GHz)
Offset +
Modify plus offset
frequency for
each channel, as
required
Offset -
Modify minus
offset frequency
for each channel,
as required
D
Main Tab
Close
Configurator
window
Radio Control
Save All
Settings to File
Save
Configuration
File window is
displayed
Save file
Program All
Settings to Radio
And/Or
Preset
configuration
settings are
loaded into the
radio.
Disconnect
Preset
Operations
And/Or
Active Preset
Menu
Select Preset
required
Select Preset
Program Preset
Configuration
settings for only
the selected
Preset are
programmed into
radio
Note
When Save All Settings to File is selected, all Preset
configuration settings and channel plan settings, not just
the Preset settings that were changed, are saved to a file.
When Program All Settings to Radio is selected, all
Preset configuration settings and channel plan settings,
not just the Preset settings that were changed, are
programmed into the radio.
When Program Preset is selected, only the selected
Preset is programmed into the radio.
Radio Control
From Figure
5-10