User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the Display Screens
- 3.5 PTX-PRO Monitoring Operations
- 3.6 PTX-PRO Control Operations
- 3.7 Front Panel vs. Configurator Settings
- Troubleshooting
- Advanced Operation
- 5.1 Chapter Overview
- 5.2 Before You Begin
- 5.3 Create or Update a Configuration
- 5.3.1 Using the Configurator Software
- 5.3.2 Determine Licensed Options
- 5.3.3 Create New Configuration On-Line
- 5.3.4 Load and Modify Configuration Settings On- Line
- Figure 5-7: Load and Modify Configuration Settings On-Line - Sheet 1 of 5
- Figure 5-8: Load and Modify Configuration Settings On-Line - Sheet 2 of 5
- Figure 5-9: Load and Modify Configuration Settings On-Line - Sheet 3 of 5
- Figure 5-10: Load and Modify Configuration Settings On-Line - Sheet 4 of 5
- Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
- 5.3.5 Load Configuration File into Radio On-Line
- 5.3.6 Change Preset Names in On-Line Mode
- 5.3.7 Create Channel Plan Offline
- 5.3.8 Modify Channel Plan in Offline Mode
- 5.3.9 Load and Modify a Channel Plan On-Line
- 5.3.10 Load Channel Plan File into Radio On-Line
- 5.3.11 Add Licensed Option
- Installation
- 6.1 Chapter Overview
- 6.2 Unpacking
- 6.3 Initial Inspection
- 6.4 Damage in Shipment
- 6.5 Mounting and Cabling
- 6.6 Power Connections
- 6.7 Grounding
- 6.8 Audio Connections
- 6.9 Signal Connections
- 6.10 Data Connections
- 6.11 Powering Up
- 6.12 Configurator Software Installation
- 6.13 Product Modifications
- Replacement Parts
- Theory of Operation
- Index
Troubleshooting 4-6PTX-PRO User and Technical Manual
4.5 Operational Problems
Information provided on the following pages will assist you in
troubleshooting problems that arise in the operation of your PTX-
PRO.
Table 4-5: Video Problems
Problem Possible Cause Suggested Operator Action
Suggested Technical Staff
Action
Video Problems
No video. Problem with video source or
cabling
• Check video source and cabling.
• Contact technical staff.
• Check video source and
cabling.
• Call MRC Technical Support.
Transmitter and Receiver
compatibility problems
• Verify Transmitter and Receiver are both
operating in the same digital mode.
• Verify Transmitter and Receiver are both
operating on the same frequency. If
frequency offsets are used, verify offsets are
identical between Transmitter and Receiver.
• Contact technical staff.
• Call MRC Technical Support
Video source configuration
problem
• Verify PTX-PRO front panel settings match
video source inputs.
• Contact technical staff.
• Verify video inputs match
Configurator software settings.
• Call MRC Technical Support.
For video problems, See Table 4-5; for general system problems,
See Table 4-6 on page 4-7.