User Manual
Table Of Contents
- Notices
- Contents
- Introduction
- Product Description
- Routine Operation
- 3.1 Chapter Overview
- 3.2 Overview of Controls, Indicators and Connectors
- 3.3 Preparing for Operation
- 3.4 Using the Display Screens
- 3.5 PTX-PRO Monitoring Operations
- 3.6 PTX-PRO Control Operations
- 3.7 Front Panel vs. Configurator Settings
- Troubleshooting
- Advanced Operation
- 5.1 Chapter Overview
- 5.2 Before You Begin
- 5.3 Create or Update a Configuration
- 5.3.1 Using the Configurator Software
- 5.3.2 Determine Licensed Options
- 5.3.3 Create New Configuration On-Line
- 5.3.4 Load and Modify Configuration Settings On- Line
- Figure 5-7: Load and Modify Configuration Settings On-Line - Sheet 1 of 5
- Figure 5-8: Load and Modify Configuration Settings On-Line - Sheet 2 of 5
- Figure 5-9: Load and Modify Configuration Settings On-Line - Sheet 3 of 5
- Figure 5-10: Load and Modify Configuration Settings On-Line - Sheet 4 of 5
- Figure 5-11: Load and Modify Configuration Settings On-Line - Sheet 5 of 5
- 5.3.5 Load Configuration File into Radio On-Line
- 5.3.6 Change Preset Names in On-Line Mode
- 5.3.7 Create Channel Plan Offline
- 5.3.8 Modify Channel Plan in Offline Mode
- 5.3.9 Load and Modify a Channel Plan On-Line
- 5.3.10 Load Channel Plan File into Radio On-Line
- 5.3.11 Add Licensed Option
- Installation
- 6.1 Chapter Overview
- 6.2 Unpacking
- 6.3 Initial Inspection
- 6.4 Damage in Shipment
- 6.5 Mounting and Cabling
- 6.6 Power Connections
- 6.7 Grounding
- 6.8 Audio Connections
- 6.9 Signal Connections
- 6.10 Data Connections
- 6.11 Powering Up
- 6.12 Configurator Software Installation
- 6.13 Product Modifications
- Replacement Parts
- Theory of Operation
- Index
Troubleshooting 4-5PTX-PRO User and Technical Manual
E034 TX Temperature Error • Check PTX-PRO to be sure it is not
too close to sources of heat.
Relocate PTX-PRO, if possible.
• Verify PTX-PRO has room around it
for air circulation. Move objects
preventing air flow.
• Contact technical staff.
If errors persist with proper location and airflow and
correct power is connected, unit has suffered internal
failure. Call MRC Technical Support.
E038 50 Ohm Coax Current Error • Contact technical staff. Call MRC Technical Support.
E039 50 Ohm Coax Voltage Error
E03A 50 Ohm Coax Power Error
E03B TX Circular Connector
Current Error
• Verify all power cables are properly
connected and are not damaged.
• Verify correct input power is being
applied to the PTX-PRO.
• Contact technical staff.
If errors persist with correct power connected, unit has
suffered internal failure. Call MRC Technical Support.
E03C TX Circular Connector
Voltage Error
E03D TX Circular Connector
Power Error
E03E TX DC Bus Error • Contact technical staff. Call MRC Technical Support.
E03F TX Fan Fault • Contact technical staff. Call MRC Technical Support.
Table 4-4: Primary Error Codes (Continued)
Error
Code
Meaning Suggested Operator Action Suggested Technical Staff Action