User Manual Part 2

Advanced Operations 5-34MTX5000 User and Technical Manual
Notes
When saving Presets in the following steps, Preset
A thru Preset J are factory default Presets. The
factory default Preset numbers cannot be changed.
Notes
To change the default Preset number, perform step
20 and go to step 21.
To accept the next available Preset number, go to
step 21
20. Select the CLR key and enter the Preset number
required.
21. Select the ENT key and observe the Are you sure?
confirmation screen is displayed. See Figure 5-76.
Figure 5-76: Confirmation Screen
22. Select the YES option button and observe the Please
Wait! message box is displayed. See Figure 5-77.
No
Are you sure?
Yes
Figure 5-77: Please Wait Message Box
23. After a short delay, observe the Save As Preset
screen is displayed.
24. Select the Main option button and observe the Main
screen is displayed.
5.4.4 Create or Update Digital LMS-T Preset
Configuration Settings in Local Mode
The procedure required to create a new custom digital LMS-T
Preset configuration or to update an existing digital LMS-T
Preset configuration is contained in the following steps.
When preparing a new digital LMS-T Preset, you must first select
an existing digital LMS-T Preset from either the digital LMS-T
factory default Preset or from your own custom digital LMS-T
Presets. The selected Preset will be used as a “make-from” to
prepare the new digital LMS-T Preset configuration.
Please note that while factory default Presets may be used to
prepare a new Preset configuration, these factory default
Presets cannot be changed or deleted. They can only be
used as “make-froms”.
When the new configuration is prepared using the factory default
Preset, it cannot be saved with the factory Preset number or
Preset name. A new Preset number and Preset name must be
assigned to the new Preset.
No
Please Wait!
Yes