User Manual Part 2

Advanced Operations 5-104MTX5000 User and Technical Manual
10. Enter your password, select the Enter key, observe
Please Wait is briefly displayed, the Operation Mode
screen is briefly displayed, and observe the MTX5000
IDU automatically re-boots.
11. Observe the Main page is displayed and the Preset
description text box indicates Default Presets.
Perform “Select Preset” on page 3-24 to select a
Preset, as required.
12. Perform “Local Mode Password Control” on page 5-3.
13. Perform “Set Network Addresses for Remote
Operation” on page 5-109.
5.6.2 Save Preset Configurations to a File
The procedure required to save the current Preset configuration
settings contained in your MTX5000 IDU to a USB memory
device is contained in the following steps. Saving the Preset
configuration settings to a USB memory device provides you
with a backup of all custom Presets that have been prepared and
saved in your MTX5000 IDU.
After the Preset configuration settings are saved to a USB
memory device, the USB memory device may be used to load
the same Preset settings into another MTX5000 IDU.
If the Preset settings are to be loaded into another MTX5000
IDU, the IDU must contain the same hardware configuration
options and must have the same licensed options as the IDU
from which the Preset configuration settings were saved to the
USB memory device.
Note
In the following steps, the color LCD display option
buttons may be selected using either the touch
screen or the function keys and the SEL key.
1. Verify the MTX5000 IDU is powered up. See
”Powering the MTX5000 System” on page 3-7.
2. Observe the Main screen is displayed. See Figure 5-
211.
Figure 5-211: Main Screen - Typical
3. Select the Main screen PA operation button for PA
Off, as required.
4. Select the L/R option button for L (local mode), as
required.
5. Select the Setup option button and observe the Setup
screen is displayed. See Figure 5-212 on page 5-105.
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 H
RFU1
No RF
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status -> PA Off
SUM
ODU
IDU
RF
L/R
L
L
PA
Operation
Button