User Manual Part 2

Advanced Operations 5-78MTX5000 User and Technical Manual
When using a custom user Preset as a “make-from”, the new
Preset should be saved with a new Preset number.
If you select an existing user Preset number when saving the
new Preset, the original custom Preset will be overwritten and
cannot be recovered. The only way to restore a Preset that has
been overwritten is to re-enter the custom Preset data from
scratch.
If you are updating configuration settings on an existing custom
Preset, when you save the configuration settings, the Preset
number will automatically be increased to the next available
Preset number. You must enter and save the configuration
settings using the original Preset number.
Note
In the following steps, the color LCD display option
buttons and pull-down menu options may be
selected using either the touch screen or the
function keys and the SEL key.
1. Verify the MTX5000 IDU is powered up. See
”Powering the MTX5000 System” on page 3-7.
2. Observe the Main screen is displayed. See Figure 5-
185.
Figure 5-185: Main Screen - Typical
3. Select the L/R option button for L (Local), as required.
4. Select the PA operation button for PA Off, as required
5. Select the Setup option button and observe the Setup
screen is displayed.
6. Select the Radio option button and observe the Radio
screen is displayed.
7. Select the Next option button and observe the Radio -
2 screen is displayed.
8. Select the Remote Ctrl Option button and observe
the Select Remote Ctrl Opt screen is displayed.
9. Select the Remote option button and observe the
Radio - 2 screen is displayed.
10. Select the Main option button, observe the Main
screen is displayed, and observe the L/R option button
indicates R (Remote).
Note
In the following step, XXX.XXX.X.XX is the IP
address of your MTX5000 IDU.
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 H
RFU1
No RF
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA Off
SUM
ODU
IDU
RF
L/R
L
L
PA
Operation
Button