User Manual Part 2

Analog Color Bar Generator B-10MTX5000 User and Technical Manual
Figure B-13: Color Bar Generator Default Screen
3. Press control switches 3 and 4 simultaneously for
approximately 5 seconds.
- The video display should now look like Figure B-14.
- The cursor will be positioned at the first character field
of Text Line B. The first character field will be
highlighted in inverse video.
- Note that the second line (TEXT LINE B) is for editing
reference only and cannot be changed.
Figure B-14: Text Line B Display
Text Line A
(16 Characters
Maximum)
Text Line B
(16 Characters
Maximum)
MRC - BOSTON
REMOTE 1
Remote 1
TEXT LINE B
Text Line B
(16 characters
Maximum)
Not Editable
Inverse Video
Highlight
R
4. The Color Bar Generator will now be in the Subset
Mode. To use Character Mode go to
step 6.
5. To jump up or down in the list of subsets, press control
switches 1 or 3 until the you reach the desired subset.
See Table B-4 on page B-18.
Note
Perform step 6 thru step 8 for each character field
you wish to change.
6. Press control switch 4 to enter Character Mode.
7. Press control switches 1 or 3 to scroll up or down in
the full character set until you reach the desired
character. See Table B-3 on page B-17.
8. Press control switch 4 to move to the next character
field. The next character field will be highlighted in
inverse video.
9. When all of Text Line B is correct, press any 3 control
switches simultaneously to save Text Line B into
memory.
10. Observe the screen flashes briefly as Text Line A is
stored. This is normal.
B.3.6 Configure Control Line
The Control Line contains seven character fields. Each
character field controls a particular aspect of the Color Bar
Generator’s operation. Each character field can have a value of
0 through 7 only. Alphabetic characters and character subsets
are not used. See Figure B-15 on page B-11 and Table B-1 on
page B-11.