User Manual Part 1

Routine Operation 3-39MTX5000 User and Technical Manual
Note
In the following steps, option buttons may be
selected using either the touch screen or the
function keys and the SEL key.
1. Select the Preset to be monitored per “Select Preset”
on page 3-24, as required.
Notes
If the Preset to be monitored is an External IF Input
Preset, status settings are not applicable.
If the Preset to be monitored is an analog Preset,
go to step 2.
If the Preset to be monitored is a digital COFDM
ASI Preset, go to step 5.
If the Preset to be monitored is a digital COFDM,
LMS-T, DVB-S, or digital IP Preset, go to step 11.
2. Observe the Main screen is displayed. See Figure 3-
70.
Figure 3-70: Main Screen (Analog Mode) - Typical
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 V
RFU2
7US
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status Setup
Status ->
PA On
SUM
ODU
IDU
RF
L/R
H
L
3. Select either Status option button and observe the
selected analog Preset status screen is displayed.
See Figure 3-71.
Figure 3-71: Status Screen (Analog Mode) - Typical
4. When review of the analog Preset Status screen is
complete, select either of the Main option buttons and
observe the Main screen is displayed. Procedure is
complete.
5. Observe the Main screen is displayed. See Figure 3-
72 on page 3-40.
Y
Modulation
Audio
4830 KHz
Video Composite
Video
Deviation
3MHz
<- Main
Setup
Main ->
PA On
SUM
ODU
IDU
RF
L/R
H
On
4830 KHz
4830 KHz
4830 KHz
Y
N
N
On
On
On
RF Out
FM
xx dB
L