User Manual Part 2

Advanced Operations 5-117MTX5000 User and Technical Manual
Figure 5-240: Firmware Update Screen - Typical
10. Disconnect the USB memory device and adapter from
the IDU front panel USB 2.0 connector.
11. Select the Cancel option button, and observe the
Main screen is displayed after a short delay.
12. Press the power switch to off, wait 10 seconds
minimum, and press the power switch to on.
5.9 License Manager
This section describes how to add factory licensed options to
your MTX5000 IDU. Only licensed options applicable to the
hardware options contained in your MTX5000 IDU can be
installed in your radio.
Your MTX5000 IDU does not have to be returned to the factory
to add licensed options applicable to your MTX5000 IDU
configuration. The internal software contains a license manager
feature that allows you to add licensed options to your IDU that
were not initially ordered with your radio.
The license manager procedure can be performed with the
MTX5000 IDU disconnected from the system or can be
Firmware Update
Update Cancel
Current Version
New Version V.0.4.Y
V.0.4.Y
performed when the IDU is installed in its normal rack-mounted
position.
It is important, however, that the MTX5000 must not be
transmitting when these procedures are performed.
When performing procedures contained in this section, you must
observe the following CAUTIONS to avoid corrupting software.
CAUTION
Avoid damage to the color LCD display
panel!
The color LCD display panel touch screen
may be damaged if a sharp, hard-pointed
object, such as a pencil or a pen, is used to
select the displayed options.
Touch screen options must only be selected
using your fingers, a soft-pointed stylus, or
the front panel function keys.
Damage to the color LCD display panel
caused by using a hard-pointed object or
other misuse may void your warranty on
the MTX5000 IDU.
CAUTION
Do not power down the MTX5000 system
when the software update progress bar is
displayed, as the software update can
become corrupted.