User Manual Part 2

Advanced Operations 5-113MTX5000 User and Technical Manual
Figure 5-234: Trap Config Screen - Typical
27. Select the Dest. Address option button and observe
the numeric keypad is displayed.
28. Enter the destination address, select the ENT key, and
observe the Trap Config screen is displayed.
29. Select the Port # option button and observe the
numeric keypad is displayed.
30. Enter the port number required, select the ENT key,
and observe the Trap Config screen is displayed.
31. Select the Main option button and observe the Main
screen is displayed.
32. Press the front panel power switch to off, wait a
minimum of 10 seconds, and press the power switch
to on. When the Main screen is displayed, go to the
following step.
Trap Config Dest. Address
Back
192.168.1.2
Port # 162
Main
Notes
The following steps verify the correct IP Address,
Subnet Mask, Gateway, and DNS Server
addresses have been correctly entered by verifying
that you can connect to your MTX5000 System
from a remote PC.
If the addresses have not been correctly entered,
you will not be able to connect from a remote PC.
Repeat from step 5 to verify or correct addresses.
If all addresses have been correctly entered and
you cannot connect from a remote PC, contact
your Network Administrator for assistance.
33. Verify your MTX5000 IDU ETHERNET connector is
properly connected to your network.
34. At the remote PC, open your web browser, enter the IP
address for your MTX5000 IDU, and press the PC
keyboard Enter key.
35. After a short delay, observe the remote screen display
appears on your PC. See Figure 5-235 on page 5-
114.