User Manual Part 2

Advanced Operations 5-109MTX5000 User and Technical Manual
Figure 5-225: Please Wait Message Box
12. When the Please Wait! message box disappears, go
to the following step.
13. Disconnect the USB memory device and USB-A to
USB-B adapter from the IDU front panel USB 2.0
connector.
14. Select the Main option button and observe the Main
screen is displayed.
5.7 Set Network Addresses for
Remote Operation
The steps required to set the radio network, file network, and
trap configuration addresses are contained in the following
procedures. These procedures may only be performed in the
Local mode of operation.
CAUTION
Avoid damage to the color LCD display
panel!
The color LCD display panel touch screen
may be damaged if a sharp, hard-pointed
object, such as a pencil or a pen, is used to
select the displayed options.
No
Please Wait!
Yes
Touch screen options must only be selected
using your fingers, a soft-pointed stylus, or
the front panel function keys.
Damage to the color LCD display panel
caused by using a hard-pointed object or
other misuse may void your warranty on the
MTX5000 IDU.
The procedure required to set the network addresses to allow
operation of your MTX5000 System from a remote location is
contained in the following steps.
Before proceeding with this procedure, you must obtain
valid Radio IP, Subnet Mask, Gateway, and DNS Server
addresses from your Network Administrator. All addresses
must be properly entered into your MTX5000 IDU before you can
operate your MTX5000 System from a remote location.
It is important that the MTX5000 must not be transmitting
when this procedure is performed.
When updating the software in the IDU, you must observe the
following CAUTIONS to avoid corrupting software.
CAUTION
Do not power down the MTX5000 system
when the software update progress bar is
displayed, as the software update can
become corrupted.