User Manual Part 2

Advanced Operations 5-102MTX5000 User and Technical Manual
Note
Procedures contained in this section may only be
performed in the Local mode.
The procedures required to save Preset configuration files
contained on your MTX5000 IDU to a USB flash drive, also
referred to as a thumb drive, memory stick, or memory device,
and to load Preset configuration files into your MTX5000 IDU are
contained in the following paragraphs. The procedures
contained in these paragraphs can only be performed in the
Local mode.
5.6.1 Restore Presets to Defaults
The procedure required to restore all custom Presets to the
factory default Presets is contained in the following steps.
Prior to performing this procedure, it is highly recommended that
you make a copy of any custom Preset files by performing “Save
Preset Configurations to a File” on page 5-104.
When performing the following steps, all custom Presets will be
deleted and only the factory default Presets will remain. In
addition, the password and IP address will also be changed to
the factory defaults.
Note
In the following steps, the color LCD display option
buttons and pull-down menu options may be
selected using either the touch screen or the
function keys and the SEL key.
1. Verify the MTX5000 IDU is powered up. See
”Powering the MTX5000 System” on page 3-7.
2. Observe the Main screen is displayed. See Figure 5-
205.
Figure 5-205: Main Screen - Typical
3. Select the Main screen PA operation button for PA
Off, as required.
4. Select the L/R option button for L (local mode), as
required.
5. Select the Setup option button and observe the Setup
screen is displayed. See Figure 5-206.
Figure 5-206: Setup Screen
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 H
RFU1
No RF
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA Off
SUM
ODU
IDU
RF
L/R
L
L
PA
Operation
Button
Setup
User
Main
Radio