User Manual Part 2

Advanced Operations 5-74MTX5000 User and Technical Manual
When preparing a new analog Preset, you must first select an
existing analog Preset from either one of the analog factory
default Presets or from your custom user analog Presets. The
selected Preset will be used as a “make-from” to prepare the
new user analog Preset configuration.
Please note that while factory default analog Presets may be
used to prepare a new Preset configuration, these factory
default Presets cannot be changed or deleted. They can only
be used as “make-froms”.
When the new configuration is prepared using the factory default
Preset, it cannot be saved with the factory Preset number or
Preset name. A new Preset number and Preset name must be
assigned to the new Preset.
When using a custom user Preset as a “make-from”, the new
Preset should be saved with a new Preset number.
If you select an existing user Preset number when saving the
new Preset, the original custom Preset will be overwritten and
cannot be recovered. The only way to restore a Preset that has
been overwritten is to re-enter the custom Preset data from
scratch.
If you are updating configuration settings on an existing custom
user Preset, when you save the configuration settings, the
Preset number will automatically be increased to the next
available Preset number. You must enter and save the
configuration settings using the original Preset number.
Note
In the following steps, the color LCD display option
buttons and pull-down menu options may be
selected using either the touch screen or the
function keys and the SEL key.
1. Verify the MTX5000 IDU is powered up. See
”Powering the MTX5000 System” on page 3-7.
2. Observe the Main screen is displayed. See Figure 5-
181.
Figure 5-181: Main Screen - Typical
3. Select the L/R option button for L (Local), as required.
4. Select the PA operation button for PA Off, as required
5. Select the Setup option button and observe the Setup
screen is displayed.
6. Select the Radio option button and observe the Radio
screen is displayed.
7. Select the Next option button and observe the Radio -
2 screen is displayed.
8. Select the Remote Ctrl Option button and observe
the Select Remote Ctrl Opt screen is displayed.
9. Select the Remote option button and observe the
Radio - 2 screen is displayed.
10. Select the Main option button, observe the Main
screen is displayed, and observe the L/R option button
indicates R (Remote).
Channel 1 0Offset
Antenna Ant. Pol.Antenna1 H
RFU1
No RF
RF Band
Preset A
Analog
4.83 & 5.8, 3MHz Vid Dev
RF Output
XX
dBm
<- Status
Setup
Status ->
PA Off
SUM
ODU
IDU
RF
L/R
L
L
PA
Operation
Button