User Manual Part 2

Advanced Operations 5-73MTX5000 User and Technical Manual
Notes
To change the default Preset number, perform step
106 and go to step 107.
To accept the next available Preset number, go to
step 107.
106. Select the CLR key and enter the Preset number
required.
107. Select the ENT key and observe the Are you sure?
confirmation screen is displayed. See Figure 5-179.
Figure 5-179: Confirmation Screen
108. Select the YES option button and observe the Please
Wait! message box is displayed. See Figure 5-180.
Figure 5-180: Please Wait Message Box
No
Are you sure?
Yes
No
Please Wait!
Yes
109. After a short delay, observe the Save As Preset
screen is displayed.
110. Select the Main option button and observe the Main
screen is displayed.
5.5 Create or Update Preset
Configuration Settings in Remote Mode
The procedures required to create or update Preset
configuration settings in the Remote mode using a remote PC
are contained in the following paragraphs. Preset configuration
settings may be created or updated for the following types of
Presets:
• Analog FMT Presets
• Digital COFDM Presets
• Digital ASI Presets
• Digital LMS-T Presets
• Digital DVB-S Presets
• Digital IP Presets.
Please note that an External IF In Preset is available for
normal operation using the factory default External IF In
Preset, but no configuration settings may be made to this
Preset. No procedures are therefore applicable or are provided
for External IF In Presets.
5.5.1 Create or Update Custom Analog Preset
Configuration in Remote Mode
The procedure required to create a new custom user analog
Preset configuration or to update an existing user Preset
configuration in the Remote mode is contained in the following
steps.