User Manual Part 2

Analog Color Bar Generator B-13MTX5000 User and Technical Manual
Figure B-17: Control Line Display
Note
Repeat step 5 and step 6 for each character field
you wish to change.
5. Press control switches 1 or 3 to scroll up or down
through numbers 0 through 7 until you reach the
desired number.
6. Press control switch 4 to move to the next character
field. The next character field will be highlighted in
inverse video.
7. When the Control Line is correct, press any 3 control
switches simultaneously to save the Control Line into
memory.
8. Observe the screen flashes briefly as Text Line A is
stored. This is normal.
2 1 3 3 4 7 0
Control Line
Control Line
(7 Characters
Maximum)
Not Editable
Inverse Video
Highlight
2
Character
Fields
Color settings (fields 6 and 7)
1
7
0
37
B.3.7 Check the Configuration
When all the characters and parameters have been entered,
check to be sure the Color Bar Generator is operating the way
you want it to. Perform this check before you install the
MTX5000 IDU in its rack.
Check Text Lines
1. Verify the “Preliminary Setup Procedure” on page B-4
has been performed.
2. Verify the Color Bar Generator default screen is
displayed. See Figure B-18.
Figure B-18: Color Bar Generator Default Screen
3. Verify the Color Bars screen is displayed on the
MTX5000 IDU color LCD display panel and verify the
Color Bars screen On option button is selected. See
Figure B-19 on page B-14.
Text Line A
(16 Characters
Maximum)
Text Line B
(16 Characters
Maximum)
MRC - BOSTON
REMOTE 1