User Manual Part 2

Analog Color Bar Generator B-12MTX5000 User and Technical Manual
The procedure required to configure the Color Bar Generator
display control line is contained in the following steps.
1. Verify the “Preliminary Setup Procedure” on page B-4
has been performed.
2. Verify the Color Bar Generator default screen is
displayed. See Figure B-16.
5 Sets the position of Text Line B on the screen.
Each increment in value moves the text line down
a small amount.
0 = top of screen
7 = bottom of screen
NOTE - If the position values for Text Line A and
Text Line B are the same, Line A and Line B are in
the same location. In this case only Line A will be
visible.
6 Sets the foreground color of both text lines.
0 = white
7 = black
See Figure B-15 on page B-11 for which value
sets which color.
7 Sets the foreground color of both text lines.
0 = white
7 = black
See Figure B-15 on page B-11 for which value
sets which color.
Table B-1: Control Line Parameters
Figure B-16: Color Bar Generator Default Screen
3. Press control switches 2 and 4 simultaneously.
4. The video display should now look like Figure B-17 on
page B-13.
The cursor will be positioned at the first character field
of the Control Line.
- The first character field will be highlighted in inverse
video.
- Note that the second line Control Line is for editing
reference only and cannot be changed.
Text Line A
(16 Characters
Maximum)
Text Line B
(16 Characters
Maximum)
MRC - BOSTON
REMOTE 1